Novotechnik MUP100/150

Special features
* Interface module for position
sensors
* available with electrical isolation
(DC/DC transformer) as
an option
* standardized output signals
0… 10 V
± 10 V
0… 20 mA
4… 20 mA
± 20 mA
* outstanding linearity
* extremely low temperature
drift 20 ppm/K (typical value)
* designed for standard
DIN EN 50022 mounting rail
fixture
The signal conditioner supplies
the potentiometric sensors
with a highly stable constant
voltage. The wiper signal
is picked off without load via a
high-resistance input stage
and transformed into a proportional
standardized output
signal.
The excellent linearity and low
temperature drift ensure full
utilization of the outstanding
benefits of conductive plastic
potentiometers, guaranteeing
the reliable, interference-free
transmission of signals in installations
with close sensor
proximity even over long distances.
The zero point and range canbe adjusted independently of
each other within wide limits
using spindle trimmers. This
facility permits standardized
output signals to be adjusted
even if the maximum path of
the sensors is not completely
utilized. The electronic
circuitry is accommodated in
a polyamide housing designed
for clipping on a standard
DIN EN 50022 mounting rail.
The wide operating voltage
range permits to be supplied
by unstabilized direct voltage
sources.
High-grade DC/DC transformers
are used in the models
with electrically isolated supply
voltage and signal conditioning.
Both for the unipolar and
bipolar standard output signals,
only one configuration is
required.
In addition, the sensor offers
an additional voltage source
of +/-15 V (only MUP 150).
This can be used, for example,
to supply the electronic
circuits of AW series potentiometers.
Order designation
MUP100/150

Novotechnik

MUP100/150

Novotechnik MUP100/150 Images